Victron Energy Battery Charger Skylla TG-24/30

One full rated output and one 4 Amp output. Charge voltage can be precisely adjusted to suit any battery system. The input for the charger is 230V at 50/60HZ. Charge voltage can be measured directly on the battery terminals in order to compensate for voltage loss due to cable resistance. An external sensor allows measuring battery temperature and compensating charge voltage accordingly.

Perfect chargers for any type of battery (any sealed or unsealed battery). Suitable for AC and DC supply (AC-DC and DC-DC operation),Except for the 3-phase input models, the chargers also accept a DC supply. Can be used as a power supply if batteries or large buffer capacitors are not available. Two outputs to charge 2 battery banks (24V models only). The second output, limited to approximately 4A and with a slightly lower output voltage, is intended to top up a starter battery. Comes with a battery temperature sensor.

Specifications :
Input voltage (V AC) : 230
Input voltage range (V AC) : 185-264
Input voltage range (V DC) : 180-400
Frequency (Hz) : 45-65
Power factor 1
Charge voltage 'absorption' (V DC) : 28,5
Charge voltage 'float' (V DC) : 26,5
Charge current house batt. (A) : 30 (limited to 22 A at 110V AC)
Charge current starter batt. (A) : 4 A
Charge characteristic : IUoUo (three step)
Battery capacity (Ah) : 150-300 Ah
Temperature sensor √
Can be used as power supply √
Remote alarm Potential free contacts 60V / 1A (1x NO and 1x NC)
Forced cooling √
Protection : Output short circuit, Battery reverse polarity detection, Battery voltage too high, Temperature too high.
Operating temp. range : -40 to +50°C (-40 - 122°F)
Humidity (non-condensing) max 95%

Enclosure :
Material & Colour aluminium (blue RAL 5012)
Battery-connection M8 studs
230 V AC-connection screw-clamp 2,5 mm² (AWG 6)
Protection category IP 21
Weight (kg) 6 kg
Dimensions hxwxd (in mm) 365x250x147

Packing List :
-Main Unit
-Accesories (Power cable, 2x rubber tape, cable ties)